Waters Network Systems ProSwitch 2800MR Installation Guide

INSTALLATION GUIDE AND OPERATING MANUAL ProMedia Fast Ethernet Media Converters 100Mbps Single Port Ethernet Media Converters Fo

ProMedia-100 Manual Page 9 4. Connect the Receive (RX) port (dark colored post) on the ProMedia-100 to the Transmit (TX) port of the remote devic

ProMedia-100 Manual Page 10 plug. Both types include a lightweight DC power cord to the applicable power jack on the media converter unit. 4.2 F

ProMedia-100 Manual Page 11 5.2 When Calling for Assistance Please be prepared to provide the following information: 1. A complete description

ProMedia-100 Manual Page 12 Ship the package to: Waters Network Systems Attention: Customer Service 945 37th Avenue, NW Rochester, MN 559

ProMedia-100 Manual Page 1 TABLE OF CONTENTS Page 1.0 SPECIFICATIONS...

ProMedia-100 Manual Page 2 1.0 SPECIFICATIONS 1.1. Technical Specifications Performance: Data Rate: 100 Mbps Half- or Full-Duplex, auto-sens

ProMedia-100 Manual Page 3 1.2 Ordering Information Waters Network Systems reserves the right to change specifications and/or model offerings w

ProMedia-100 Manual Page 4 or power strip. Each converter features a full set of LEDs that convey essential diagnostic and status information. S

ProMedia-100 Manual Page 5 3.0 INSTALLATION This section describes the installation of the ProMedia-100 media converters, including location, se

ProMedia-100 Manual Page 6 full-duplex media (15,000 m) [57/15,000 x 100% = 57%]. The length of twisted pair Segment Y is 12m (40 ft). This is 12

ProMedia-100 Manual Page 7 Table 3.4b: Worst case round-trip delay for Fast Ethernet device components* Component Round-trip delay in Bit Times

ProMedia-100 Manual Page 8 It is obvious that using twisted pair wiring to connect the hubs would enable the interconnect length to be the 100 met